🚽 Superior Pump 93501: Reliable 1/2-HP Cast Iron Sewage Pump with Tethered Float Switch Review

This is my very first drain pump replacement taking a full day maybe even a full weekend and at the end of this dirty and smelly job once you have taken all the measurements tape everything down to the millimeter and finally start pouring water into the hole, you will find that the float is too small to rise fast enough before the water flows back from the toilet into the sewer pipe; They could have designed a small boat-like float that could be fitted under the existing float to give it more…

This is a replacement for a clogged 3/4hp pump. It was significantly lighter and the capacity was very close to 3/4 and well above my normal usage. Note that the pump's float switch may not be in the ideal position if you are installing it in a well. For example, if you make good use of the standard size and lower the pump dead center, there will definitely not be enough room to change. Therefore, you must install the pump so that it is almost against the wall AGAINST the pump's float switch…

Bought this pump in August 2015. My neighbor has a mirror image of my house and it was built at the same time he needed to replace his original drain pump which failed and flooded much of his basement. My drain pump was fine and I decided to replace it because she died at the same age. I did a little research and found this to be a good option. Unfortunately, this turned out to be a bad buy. On September 22, 2018 my wife discovered our drain pump overflowing as she started her laundry at around