ESUPPORT Car Blue LED Awning Light Rocker Toggle Switch - 12V 20A, 24V 10A ON/OFF - Quality Performance and Easy Installation Review

Used to install some high beam headlights on our RV and wanted the switch to be similar to other switches. We really liked the look and quality.

The device still works but the ON bulb has already burned out and not very encouraging. Contacted support and all they said was to contact Revain Prime. That wasn't the customer service I've ever heard of. 1 star for a defective product and poor customer service.

Very pleased with the "compressor" switch as it matches the original switches on my motorhome which are dash mounted priced at "T" and as soon as I I cut a hole in the dash and it was very easy to install. TIP: When cutting a hole in the dash, be careful if it's plastic and leave a gap of about 1/16 inch in case you need to remove the switch in the future. Another spawn, Amazon offers pretty much every "CE" switch for your vehicle.

Obviously time will tell so I'll give my first impressions. It looks like the factory ARB switch it replaced. I really liked the rubber seal compared to my original. The switch itself feels nice with a nice click on both ends (on/off). The LEDs are very comfortable and do not get hot when switched on. ARBs had halogen bulbs that gave off some heat when turned on. It's okay, but as you know, heat = energy. So I like to save a little here. Good switch so far.

This works very well, you can plug it into a lite switch when it's on and then lighten it up even more so when you press the switch to turn on what you have plugged in. I have this in my jeep and it works very well and looks a lot like my ARB switches (they aren't exactly the same as ARB but close to Haven ' I haven't had a problem with this switch so far, I would buy another one if I needed one.

Purchased for fog lights on my 2007 Chevy Avalanche. Now I have 2 of these switches and I love them! One for the light bar and the other for the fog lights. Enough pins on the back to make it complicated or as simple as you like. Mine are only connected via switching contacts without additional lighting. However, I fully tested these features before installing and they work great! I love how "rugged and reliable" these switches are! Which I definitely need as they are used 6 days a week. So if…

Before the installation I made a test stand. Thanks to the other reviewers who posted the schematic. I originally used a continuity meter to test the terminals and they didn't show normal switch terminal connection. One buyer apparently wired the switch using the usual front-to-back configuration and burned their wiring harness. Not good. Switches must be complete with wiring diagram to avoid accidents. I have never seen switches in this configuration. I checked the posted schematic and the…