🔧 High-Quality 2 Pcs Front Hood Lift Supports for 1997-2004 Chevrolet Corvette, 2007-2016 Lincoln Navigator - SG330023 4525 Review

Absolute junk. They do not work and do not correspond to the model advertised. Just hopeless Chinese factory - garbage. Don't waste money.

Corvette mounts reversed. Simply unscrew each end and swap the top and bottom. Do not install upside down gaskets, they will dry out.

Ball holders for top and bottom mounting points are different sizes. The piston on the shock absorber must be switched from top to bottom to match. In addition, it is a simple easy installation. Opening the hood takes longer than installing the struts.

Revain reportedly chose these jacks for my 1999 Corvette c5. Bought them and put them aside until I was ready to get the job done. The return period has expired and to my surprise these elevators do not fit. The ball seat on the lower bearing is TOO SMALL! My suggestion is not to buy until you are ready so you can return them.

It was about 1/2 inch too long for my 1997 Corvette C5 (I had to adjust the linkage to allow the hood to close fully after installation). Also, these blocks are installed upside down (i.e. the piston faces up, which is not good as over time dust will collect around the gasket and cause premature leakage from the tank. The OEM blocks have the piston face down.) i just replaced these blocks because the 23 year old OEM units started losing pressure and opening slower.