Header banner
Revain logoHome Page
tecke stainless honing chisel sharpening logo

TECKE Stainless Honing Chisel Sharpening Review

3

·

Poor

Revainrating 2 out of 5  
Rating 
2.0
💄 Finishing Products, 🪚 Abrasive & Finishing Products

View on AmazonView on ЯM

Media

(4)
img 1 attached to TECKE Stainless Honing Chisel Sharpening
img 2 attached to TECKE Stainless Honing Chisel Sharpening
img 3 attached to TECKE Stainless Honing Chisel Sharpening
img 4 attached to TECKE Stainless Honing Chisel Sharpening

Description of TECKE Stainless Honing Chisel Sharpening

Brass and stainless steel roller design, give you more choice, and make move back and forth without restriction during sharpening. Keep the same direction, anti-slip, smooth and safe. You can adjust clamping width by rotating the screw-cap, clamping width range is from 8-82mm(0.31-3.23"). Support plane iron max clamping width to 82mm(3.23") Support chisel max clamping width to 55mm (2.17"). Suitable wood chisel, planer, blade, graver, carving knife, plane iron, flat chisel edge sharpening.

Reviews

Global ratings 3
  • 5
    0
  • 4
    1
  • 3
    0
  • 2
    0
  • 1
    2

Type of review

Revainrating 1 out of 5

Best in class I found

This is the best similar product in its class that I have found. It holds the blades better, its shape holds the blades in place better and doesn't seem to freeze after a few sessions.

Pros
  • Hold one direction, non-slip, smooth and safe.
Cons
  • alt

Revainrating 4 out of 5

This good tool

One of the problems I had was the lack of instructions. It would be nice to have some sort of indication of how long the bit needs to stick out to get the right angle. It takes a little time to figure it out, and once that's done, the tool works as intended.

Pros
  • wood chisel, plane, knife, engraving machine, carving knife, plane, flat grinding the chisel blade is suitable for what you need.
Cons
  • weak

Revainrating 1 out of 5

Save time and money

with three hands The chisel clamp is very difficult to align and for the Tighten use The set screw in the knurled grip has a broken hex head The straight screwdriver slot in the knurled grip is too finely machined to allow a screwdriver The reel has no bearing. The roll is carelessly fixed on the axle and causes wobbling. It has too much play due to the use of locking brackets for attachment. The inner roller size design is too narrow and will cause wobble for bits wider than 1 inch.

Pros
  • You can adjust the clamp width by turning the cap, the clamp width ranges from 8 to 82 mm (0.31-3.23 inch)
Cons
  • Very expensive