🌡️ Cylindrical Temperature Thermocouple Compatible Thermistor: High-Performance and Accurate Review

I changed the description and everything works great! However, at low temperatures this is not very accurate. My standard bed thermistor averages around 26 and this one is very jumpy, usually around 35 at room temperature but once it gets hot (around 70+) it smooths out and works great. That's probably why he says set the check time for temporary reports to 30 seconds.

Product worked very well. I really had to learn how to build my own firmware instead of using the off-the-shelf Creality firmware, but luckily it wasn't too difficult after troubleshooting. My biggest complaint is that the cord is too short. I had to run my print halfway up until I got the tools to make an extension for it. Not difficult as you can take an old thermostat wire and use it to extend it. But so far everything is working fine.

Expected literally with main shipment on 24th November, shipped on 26th November, received on the 29th and after installing it showed -14° C. After playing around with firmware mods, I blindly found the right option (#define KNOWN_HOTEND_THERMISTOR) and (#define KNOWN_HOTEND_THERMISTOR_VALUE 66). Don't forget to also include (#define HIGH_TEMP_THERMISTOR) and (#define HIGH_TEMP_THERMISTOR_TEMP 500).