🏎️ Timken HB4016A Driveshaft Center Support Bearing: Superior Quality and Durability Review

This Timken driveshaft support bearing looks exactly like the Original Equipment Spicer driveshaft support bearing. about 1/3 the price here on Revain then anywhere I could find a local.

Fits perfectly on my 2005 GMC Sierra 3500, eliminates the vibration I've had for years. It's difficult to install without a press, but it's possible. I had to cut the old bearing off and then slowly hammer in a new one.

I could hear a hum under my 2001 Silverado 1500hd with only 80,000 miles on it. Make sure the truck is on stands and switch on the drive, don't let the truck hit you! Bearing noise heard. Replaced bearings, no more noise! Good price. The shop I contacted to install the bearing was even impressed by the price.

Perfect fit for my Silverado 2500HD Crewcab Longbed. This is a 40mm ID bearing, not a 35mm ID. If your drive shaft still has a sticker, you can use this part number to check the bearing diameter. My 20 ton press squeezed out the old bearing with no problems. A piece of the exhaust pipe was used to nail in the new bearing. No more knocking when accelerating from a standstill.

Large bearing. Make sure you have a puller or port freight press if you don't already have one. This bearing is pressed in and cannot be removed without a puller. There are many videos on YouTube showing how to do it. Oh, and you'll need a tube or something to push it back down. I just used 10x1.5 inch galvanized pipe or something. Getting dressed was a lot easier than undressing. I wish I knew beforehand.