Header banner
Revain logoHome Page
๐Ÿ”ง industrial workholding: parallel clamp by toolmakers - craft tool for power & hand tools logo

๐Ÿ”ง Industrial Workholding: Parallel Clamp by ToolMakers - CRAFT Tool for Power & Hand Tools Review

3

ยท

Poor

Revainrating 3 out of 5ย ย 
Ratingย 
2.8
๐Ÿ› ๏ธ Workholding, ๐Ÿ› ๏ธ Industrial Power & Hand Tools

View on AmazonView on ะฏM

Media

(1)
img 1 attached to ๐Ÿ”ง Industrial Workholding: Parallel Clamp by ToolMakers - CRAFT Tool for Power & Hand Tools

Description of ๐Ÿ”ง Industrial Workholding: Parallel Clamp by ToolMakers - CRAFT Tool for Power & Hand Tools

TOOLMAKERS PARALLEL CLAMP 3" - 75MM. Features hardened and tempered jaws. Clamps equipped with spring screw clip. Highly useful for holding small work together, when drilling, welding, assembling, etc.

Reviews

Global ratings 3
  • 5
    0
  • 4
    0
  • 3
    2
  • 2
    1
  • 1
    0

Type of review

Revainrating 3 out of 5

Disappointing Quality of Workholding Clamp

The industrial and scientific label is the only good thing about this clamp. Through trial and error, I found that it simply lacks durability as it broke after very little use. Not worth the investment in any capacity.

Pros
  • Industrial and scientific label
Cons
  • Lacks durability

Barely enough. Bought two, sent one back because it was scrap. Another and consequent replacement is a small step above junk. I've used good ones in the past so I know how they're supposed to work. They are very rough, not pleasant to handle and are likely to remain unloved in a toolbox drawer. Not recommended.

Pros
  • Weight
Cons
  • Some small things

Revainrating 3 out of 5

Needs some cleaning

These clips have some issues. The threads of the screws in particular are very rough and filled with sand. It takes some time to delete them. Grit can cause problems with unpredictable clamp force when tightening. The rear screws also have serrated ends that don't align with the threads. This causes the clamps to move sideways when tightened. A bit of sandpaper and a drill can clean this up and improve things a bit, but the bottom of the hole on the back of the clamps isn't square either, soโ€ฆ

Pros
  • Good
Cons
  • Obsolete