🚗 TopLight Model 3 Model Y Non-Slip Pedal Set | High Performance Foot Pedal Pads Covers | Anti-Slip Accelerator Pedals for Car Replacement | Model 3/Y Brake & Accelerator Pedal Review

They must have updated their design recently because my gas pedal had 3 rubber tabs that were sticking out to make installation easier. The brake pedal now has 2 instead of 1 in some pictures. After installation, the tabs are hidden/not visible. Overall the brake is still pretty easy to install and the accelerator is still an issue but if you read reviews buy both. I'm giving 5 stars because of the new reed design, you can do half to 3/4 of it and use the reeds to get the leverage you need the…

I was happy to find these at such a low price, please note the metal on it is not brushed or polished aluminum the textured aluminum reminds me of what is on it 25 cent gumball machine. It looks cheap and I was disappointed with the quality at first glance, I wasn't even sure if it was real metal, aluminum is so thin to begin with. Putting them on the car is a little slippery and doesn't quite fit perfectly, but you can fix that with some washers. From afar they look good and I have them…

BENEFITS: • Identical to Performance model aluminum pedals • High quality aluminum finish • Aesthetically pleasing, minimalist design that gives the car a sportier look • Stays and shows less dirt than factory rubber boots • No hassles when Slipping on wet shoes CONS: • Difficult to wrap the edges of the rear rubber around the pedals (but I forgot to follow the instructions). So follow the instructions and you probably won't run into any problems. I did it. HELPFUL INFO: • No accelerator cover,

I have to admit I was skeptical about this product for a while. Despite the bad reviews, I couldn't get over the price difference compared to the competition. I don't mind paying a little more for quality, but the reviews have been very consistent. I ordered these cases and to my delight they were the same as the Model 3 itself. The Model 3 is an affordable Tesla without compromising on quality. I can honestly say these pedal covers give me the same feeling. I have a friend who has the improved

I've read how difficult it is to install these pedal covers, especially the accelerator pedal. Here's what I did to install both in about 12 minutes: 1. Place both spacers in a ziplock bag (sandwich size was fine). Place the bag in a bowl of hot water (I used water heated to 195 degrees) for about 5 minutes.3. While the pads were warming up, I removed the old rubber brake pedal pad. There is nothing to shoot for the gas pedal.4. I took the new brake pedal out of the bag (sealed the bag and put…