🔩 VTR TR-416 1.5" Metal Valve Stem (Outer Mount) - 4 Pack by Veteran Tire and Rubber Review

Good High Pressure Valve Stems. Good length for R16 trailer wheels. They're worth the extra cost over rubber sticks. Great that they come with rubber grommets in the two most common sizes. I was able to reuse this type of valve stem by transferring it from one bike to another. It's worth it!

I am very satisfied with this product. Quality fit and finish. It was not advertised as stainless steel. However, all metal components of this valve stem are made of high quality stainless steel with the exception of the metal disc. I like the fact that the bottom of the stem is the same diameter as the rubber grommet, which is not always the case with other stem designs.

If you're tired of worrying about valve stems, you need to buy them on your next set of tires, even if their load rating is 80 lbs. put pressure on them. You can take it. So next time you get a new set of tires and they tell you if you want new valve stems, you can tell them no because they will last the life of your car. This will be the last set of valve stems you will buy. If you now have TPMS sensors on your drive card, you're out of luck.

When you first install them, they make a high-quality impression. The nut size is 14mm but note that depending on the design of your impeller it may be difficult to machine a 14mm deep recess in the impeller to tighten the valve. I installed them on a 2003 Dodge Ram with factory alloy wheels. The wheel has a drilled hole where the valve is installed so I needed a very thin walled bushing to fit that hole. I couldn't find a 14mm head that was thin enough so I had to use a 9/16" head instead. Not