🔐 Admiral Locks Tubular Cam Lock, Keyed Alike: 5/8 Inch 90° Chrome Pack of 2 - Secure Your Valuables with Removable Keys Review

Worked on a tool kit for a Delta truck. I had to sand it down a bit. A locking nut broke and I have a huge stash of nuts and can't find the right one? This is a fine thread 11mm. Just be very careful when tightening the nut. I'm going to Fastnal to get a new locking nut.

I first bought my cabinet from Lowes. But it was a floor model and had no key. But I bought anyway. I looked at the listings for Lowes and HomeDepot stores. When in the local hardware stores know the use. So I checked out the Revains website and AAAHHHhh! there it was only at the tip of my finger. I wasted all my diesel staring when all I had to do was use my fingers. So all that driving and walking while all I had to do was run my fingers. LOL Hope this helped. And have a wonderful whole day.

I wanted to replace my 751 cam locks with something more secure so I ordered these. When I got ready to install them, I found the latch didn't fit my bays. Straight latch when I needed an offset latch. After receiving the offset latches I found that they were 9mm instead of 4mm so even when latched the landing door is not secure unless I also close the side latches. Just note that you need to measure more than the camshaft for them to work.

Used these to replace the standard locks with keys on my camper van. I had to take different sizes and was happy to see that all locks had the same keys. Now their quality looks cheap from the lock cylinder to the nut to the innards. I've found that if the eccentric nut is overtightened, the lock won't turn, and if too much force is applied to the cam when locking the compartment, the lock's center pin will move closer to the edge of the key circle and do it closed. difficult to insert the key.

If you have an RV and want to protect your storage compartments this is a great lock. The key is thick and durable. I bought a 6 pack, all locks have the same keys. Tip: Before attaching the locking bar, there is a quarter turn key limit plate. Operate the key while holding the locking plate to ensure you move the key to a point where you can remove the key. Once you have determined the 1/4 turn direction, secure the locking rod with the lock nut, making sure the key can be removed when locked…

Chinese metal low price for tube lock if not from China. Bought a new tool box that didn't have the keys to the lock. After replacing the lock with this one, I was excited to install this lock. Anyway, once the lock was installed, it was pretty easy. Hand tighten the jam nut with a wrench to secure the tube lock. The part of the latch attached to the mechanism that prevents the boxes from being opened, the Chinese latch, literally broke in half. Cheap Chinese metal. Garbage, just wasted time…

I have a 4 piece tool box. Two parts were bought at the same time, the other two at different times. ALL four had different unlock keys. And there is no way to order sets with the same wrenches from the store where I bought the tool boxes. I ordered two 90s and two 180s. They had to be ordered separately, but in the same order. I doubted all four would have the same keys. But they proved me wrong! I was able to install them using the connection hardware from the toolbox locks and now I only…

I contacted Admiral Locks prior to ordering to ensure they could use the same key on all locks and they said they could. They kept their word. Good locks and work the way I wanted them to. Thank you, Admiral Locks. Update: I give them five stars for their customer service, but their locks are not very good, the key keeps getting stuck, one of the locks has turned halfway and is stuck so now you can't use the key to open the lock or to close. Locks are not very good quality. Don't buy these…