🔀 High-Quality Twidec Position Toggle Switch - KCD2 203 with Years of Reliability Review

I wired these DPDT switches correctly and the dual function auxiliary lights are working but the switch does not have an LED in any of the 3 positions it has. I can't find a solution for this. I've searched the internet for schematics for this particular type of switch and haven't found anything. At the moment I am convinced that they are defective, like the others that I have ordered.

This is exactly what I needed. I only needed one, but it's good to have a spare. I will only update this review if there are any issues with the reliability of the switches. I used this item to replace the motor on my boat's exhaust fan. I modified the original fan to run off the boat's 12 volt power system (rather than my own internal isolated setup with a single C-cell solar powered battery). I connected it to reverse (input and output) with this switch and it works fine.

They are of poor quality and short-lived. Bought 2, the first broke during installation. I take some of that responsibility as I've been squeezing the spade lugs quite hard while wiring the 12ga Romex for the two devices I'm plugging and unplugging. However, the tabs on the back of the plug are not strong enough for the rated voltage of 250V at 15 amps. With the 2nd switch I hooked it up more carefully and bent the Romex wires and it worked great for about a week. We were toggling two devices…