🌡️ Twidec/Display PID Temperature Controllers Thermostat Box 1000W 10A 110V Temperature Control with SSR 40DA, Oven Thermostatic Control Box Review

I bought a total of 3 of these devices. Although I had my first SSR failure. A bit disappointed with how quickly it broke, probably less than 200 hours of use. While this may be my fault, I may have placed it too close to a heat source (beneath the incubator with the rest of the controls) to attempt to install it remotely in hopes of prolonging its lifespan. Overall, this PID was easy to use and set up. Would buy again but might consider another SSR if the next ones don't last longer. Pretty…

I spent hundreds of dollars on two well working controllers from an American company, probably made in China. When I needed two more controllers, I decided to take a closer look at Revain. I have two of these, each feeding two 700w cartridge heaters in two 2X12X12 aluminum plates in my heat press. Your PID works great. I placed each relay on the inside of the aluminum cooler boxes. I remove the cooling fins that came with the relay. The front of the box practically does not heat up. That is…

Unfortunately I was very excited to build a smoker temperature controller with this product because it would save me time and be great value for money seemed. but without fiddling, it will display the correct temperature. It always read something within a few degrees of 150F at room temperature, a probe in ice or a probe in hot water. I would try a different thermocouple if I had one and was tempted to buy it and try it because I really wanted it to work, but there was no point throwing good…

I spent hundreds of dollars on two controllers that work well, from an American company, probably manufacturing in China. When I needed two more controllers, I decided to take a closer look at Revain. I have two of these, each feeding two 700w cartridge heaters in two 2X12X12 aluminum plates in my heat press. Your PID works great. I placed each relay on the inside of the aluminum cooler boxes. I remove the cooling fins that came with the relay. The front of the box practically does not heat up.

Unfortunately I was very happy to create a smoker temperature control with this product because it would save me time and seemed like good value for money . but no, the amount of fiddling will result in it reading the correct temperature. It always read something within a few degrees of 150F at room temperature, a probe in ice or a probe in hot water. I would try a different thermocouple if I had one and was tempted to buy it and try it because I really wanted it to work, but there was no point

I have to say I'm impressed. I use A&B Omron and high prices affect the car I design. To control my 3D printer's camera temperature, I tried this inexpensive guy. This works beyond my expectations (well, I didn't expect it to work lol). Pros: For starters, the SSR was attached to the heatsink with a screw and conductive paste, which I wasn't expecting. The contact screw and washer are of good quality, as is the material used. looks ok It works like a setting and keeps the temperature at the…