🏍️ Enhance Your Motorcycle's Performance with MASO 2PCS Universal 48mm Exhaust Silencer: Motorbike Muffler Can Insert Baffle Silencer in Sleek Black Design Review

I used it to fill two of the four pipe holes on my '06 BMW M5 with a B&B Triflow exhaust. My goal was to quieten my exhaust a bit, and that helped buy what I wasn't expecting was a 1mpg improvement in fuel economy.

Installed it on my car's exhaust, works great, got the noise down a notch, less hum but not completely deadened (which is good). As they are made for motorcycles they need a bit of work to fit them to the exhaust like mine did but would definitely recommend them.

Worked great to take my Victory Octane's secondary (crusher) exhaust to the point where I no longer have to worry about my neighbors. Be sure to use red sealant on the screws (otherwise they will dangle) and never overtighten them.

If like me you bought a bike from a young man who removed the original exhaust tips and you can't stand that kind of noise, just try pulling Tighten the set screws, the metal is very thin and when you install the screws after determining where they should be, USE THE RED LOCKTITE OR THEY WILL FALL OUT. Also, I just used a tape measure to figure out what size I need. to the muffler hole and convert it to mm. In my opinion it was 60mm Yamaha Vstar 650 2008

Very low quality. There are almost no screw threads. You have to be perfect and use a lot of effort to get the screw in, which is almost impossible when you're trying to line it up with the hole in the exhaust pipe. The welding is so sloppy and cumbersome that the part may not fit in the exhaust. The adjustable part of the muffler is meaningless as the screw below makes it impossible to install. If you're ready for a big headache but can't afford anything else, this might be for you.

I used this on my 2019 GT Charger. I removed the mufflers and resonators and installed Magnaflow mufflers. The car sounds great but at 40-45mph the rumble in the car was terrible I got this and put them in my tubes (they go deep but stop in the right place), attached them with screws and made NO MORE DRONE, but the car became very quiet, after that I took them out and played with a bit of them, I drilled the existing ones where the holes are bigger without affecting the structure, installed the