Upgrade Your Wahl Clippers With Ceramic Cutter Blade With Steel Blade - Perfect For Wahl 808, Senior Cordless, And Magic Clippers Review

Corona virus 2020 compelled me to dig out my old clippers, only to find the blades were oxidized and would not clip through my hair. Replacing the blades on my clipper thru Barber Supply, rather than replacing the clippers was a FAR less expensive thing to do. And, the free shipping arrived in two days (even though they said it would be three at check-out).The old blades came off easily by removing a pair of really short screws. Don't lose those screws because the new blades in this kit do not…

The surface piece seems fit, but had difficulty to install the bottom piece, it vibrated so much that I had to put back the old piece.

So this is a nice blade. Value for money. It fits on my wahl. Very sharp. Easy to install. The bummer is that it is a couple of millimeters wider than my original so my old attachments no longer fit. As my wahl clipper does not have a model number or anything useful to help me to find the right part, I am owning the fact that I just ordered the wrong part. I am now going to search for Attachments that fit this blade that are not from wahl as I am disappointed in them that they don’t make it…

Fits just fine in my Wahl clippers. Every now and then I have to cycle on and off because they don't sit right for a minute. After the cycling though they lay just right.

Nice cutting. Smooth blend. Just oil very well when you first attach them. I did take about 2-3 cuts before the blades would glide through and not miss any pieces of hair. Would definitely reorder again in the future

The upper blade didn't fit on the plastic post in the Whal clipper. I had to use a dremel to open up the center diamond shaped hole to get it to fit. Used a whole dremel bit to do it. Even so, the blades seize up and make a terrible racket. Pretty much a rip off. My clipper is the whal 808, just as in the description.

These are incredibly sharp and I have had no problems with them snagging or getting stuck in any way. They fit our 20+year old Wahl hair clippers perfectly, after it was dropped and one of the teeth on the old blade broke. I have no problems with them fitting with our guards, either. A great buy.

Gives nice clean cuts. Put on my Kemei and am happy with performance. The ceramic blade really isn't black though, it's more of a dark gray.

I have a trimmer from costco, MC3 model, and although the item fits.it does so barely. The smaller trimmer blade is ever so slightly smaller at the area where it sits on the vibrating mechanism. so it doesn't seat as nicely as the original did, but it does seat and it works. The main plate fit fine. no problems. The other issue is it is LOUD.i mean the trimmer was already loud to begin with, but now it's extra loud. Not sure why. I see others noted that too. Even after adjusting the screw on…

Need a new set of replacement blades for my clippers. These cut sharp and work great! A necessity for anyone needing a quality set of blades

This blade needed a little hard pushing to get on, but it went ok. These cut hair like a hot knife thru butter, they work very good!

Clip cut good. Adjust cut after clip install you must. Clip work good now. Make under hair no long for night time good! Thanks for attention.

Louder than a wood chipper and didn’t cut well. Was pulling my son’s hair. These fit on my Wahl model MC2 clippers but maybe weren’t designed specifically to replace the blades on my model. The lower blade is considerable thinner material than the original which may be why they vibrate so much more. Not recommended for the Wahl MC2.

My old blade was 5 years old and was getting dull, bought this one and tried it out yesterday and it worked great. Beauty & Personal Care.

Blades look great but I did not get the two screws that the package says it comes with so my clippers looks off right now with the gold blade and silver screws from my old blade

Super loud! It cuts but due to loudness of the ceramic blade I will not use. Its a shame cause it looks great and cuts well. The blade may not cut through tangles or knots in hair!

I purchased this to replace a damaged blade (top, not base plate) for my Wahl CMCO. Unfortunately, it does not fit, and I have been unable to find a compatible blade online. Was a good clipper .

I had concerns since this was not OFE. In my opinion this is better of course I was long overdue for a blade sharpening. These are a much needed improvement.

In my opinion this design is smoother than the one on the original blade. See difference in curve of the two blades the picture. OEM blade is over 25 dollars, where a new trimmer would cost about 45. So I tried this aftermarket. I have not have the problem of it not cutting, but pulling hair instead. The only minor issue is the horizontal hole fitting of the blade that does not fit the cam/drive or whatever it is called (See harrow) I struggled a bit fitting that properly. Other than that it…

I am a licensed barber and change our mt clipper blades about every 2 months to keep my fades clean. I purchased this ceramic blade and it hasn't lasted me at all like it should. The first two weeks it was great but started to dull and leave strays behind even after going over the same spot more than once. These are not quality blades and I truly feel I wasted money.