🔬 Double Protoboard Prototyping, Uxcell A14041800Ux1143 - Enhanced SEO Review

Ideal size for DIY guitar stompboxes (large enough for more complex RunoffGroove and DIY stompboxes, or assembling a simple distortion circuit and Lil' Smokey on the same board) and other small electronics projects; I assume I can hook up a Smokey and Tweed-y preamp to one of these amps for an outdoor amp. Plated through holes are a bonus and hard to find at these prices from typical electronics vendors. For those used to single sided breadboards, note that plated through holes are a bit more…

I've finally designed some circuits on a prototyping board that I want to make permanent. Although the projects I've done with them made me want to use strip boards instead, I don't regret picking them up. The assembly allows for a lot of flexibility, and even with my mediocre soldering skills, I was able to solder permanent circuitry onto one of these boards without too much trouble. My last project turned out to be more compact than I expected, so I had to remove some material from the…

Almost flawless. One (and only) problem I found was that the labels for the columns are inconsistent between pages, but the row numbering is fine. I have attached pictures to illustrate this, but on one side the "A" column is on the left and on the opposite side the "A" column is on the right. It's easy to make a mistake. The coordinate system on the board is essentially constant only along its short axis, not along its long axis. To be honest, that doesn't stop you from using the product, but…