🔧 Optimized Installation Kit for Walbro 400-0085 Fuel Pump Review

I ordered this hoping it was a full set and not what is pictured. Luckily it comes with everything shown plus another clip and 2 butt connectors.

Expensive but does the job. You can get a similar setup piece by piece from the parts store, minus the connector. The ones you can order in bulk online.

Buy yourself a 3/8 hose from O'Reillys. This is a difference in the hardness of day and night. I hooked it up to a Walbro 450 and after the 2nd or 3rd run I started losing fuel pressure. It turned out that the fuel spilled right through the hose.

Kit works well. The hose is too small to fit on a Walbro 450 pump without tearing the inside of the hose. Put some wd40 or other lubricant on the hose to make it easier to slide over the pump. I also had to use some sandpaper to thin the pump outlet a bit.

Bought for my E85 Walbro 450 fuel pump. Didn't need the connector because I put it in myself but bought it for the filter and dip hose. The filter came up and snapped into place with no problems. The hose, on the other hand, was too small. I spoke to the seller and he said it would fit but was very tight. I tried but I was afraid I would end up breaking the pump nipple. I ended up just ordering a 3/8" ID hose (which fits perfectly) and used that. This kit is overpriced in my opinion for what it