Header banner
Revain logoHome Page
walker products 15415a carburetor kit logo

Walker Products 15415A Carburetor Kit Review

3

·

Average

Revainrating 3.5 out of 5  
Rating 
3.3
🔊 Exhaust Systems & Parts, 🏎️ Performance Car Parts & Accessories

View on AmazonView on ЯM

Media

(1)
img 1 attached to Walker Products 15415A Carburetor Kit

Description of Walker Products 15415A Carburetor Kit

Carburetor kit (C-1). 100% OEM style components insure proper fit and assist with easy rebuilding of the fuel system as all parts match the original OEM components. High quality coated gaskets insure a proper seal and resist today's volatile fuel mixtures in the marketplace. Easy to read instructions insure a quick and easy installation with step by step rebuilding instructions including pictures. Walker fuel system repair kit includes all installation accessories including OE style clip rivets, float gauge and float specification kit.

Reviews

Global ratings 3
  • 5
    1
  • 4
    1
  • 3
    0
  • 2
    0
  • 1
    1

Type of review

Revainrating 1 out of 5

no es para jeep willys

Buy this kit for my 1955 willys jeep, on this site i was told i lost my money when the lie was applied and the lie wasn't worked

Pros
  • Weight
Cons
  • Not bad but...

Revainrating 4 out of 5

Wrong float needle for my Carter YF

I wasn't aware that the Carter YF comes with several different float needles and seats. I am restoring one of the 1959 Jeep CJ-5s. I had a short float needle about 13mm long. The needle and seat that comes with this kit is so long when installed in my carb that the float cannot be installed. There is a website that sells a kit that costs about the same but has every possible float needle and seat combination you can come across. I recommend ordering a set there.

Pros
  • Great for me
Cons
  • Negative gift

Revainrating 5 out of 5

Started my CJ3B with an old needle and seat.

Basically I needed a pump diaphragm and a shaft. And the pads worked great. The pump check valve happily replaced my control ball (after installation). The float bowl needle and included seat were too long for my application on a F-143 Willys Jeep Hurricane Carter YF carburetor. Might fit a YFA carburetor for other uses, but I can't confirm. But for the money I'm very happy and I have enough parts to run mine. I was able to thoroughly clean the tip and seat of my old needle and it became…

Pros
  • Absolutely amazing!
Cons
  • Some difficulties