Exhaust fan Soler & Palau SILENT-100 CZ, white 8 W Review

This is the third time we have bought such a fan and the seller, Blagovest, has never let us down. This time the fan came just stuffed into an empty box and someone could be damaged during transportation, for some reason they removed an additional frame from it that keeps the fan stationary. Will it work, we'll see. In general, the purchase is satisfied.

That translucent part in the photo is the so-called non-return valve. The rest will do. There is a sound, like a working computer with far from the best coolers at full power.

Works well stable, without jerks. Pros below: Easy to install if replacing the old one with the new one in the same dimensions Some cons: Not as quiet as I first thought. I got used to it as I worked. It doesn't seem to make much noise

There is a plastic marking, made perfectly, a good design, wires and contacts in an additional case. I will order more to change the entire hood in the house for these fans.

I'm going to install a whisper-quiet exhaust fan in the restroom. There is a valve that acts as a check. I wired it up to a programmable switch that was equipped with a humidity sensor. Made in Spain.

These fans have been installed in both the bathroom and the toilet. They operate at a very low decibel level; this might be compared to anything). When the fan is switched on, the draw is so strong that it can really cause you to feel a chill all over your body. Unpleasant odors dissipate instantly, and the dampness in the bathroom dries off in a very short amount of time. Simply outstanding.

Silent fans have proven themselves reliably in terms of noiselessness, due to the installed bearings. The extraction function works as expected.

Champagne was used for the finish on the lamps. The level of noise is comparable to that of a computer that is actively operating. Fixed on porcelain stoneware and connected to a traditional switch. In overall, I am happy with everything, although I wish it were cheaper.

Has some pros: Comparatively quieter than others, effectively removes moisture from the bathroom, and performs well in meeting commitments. Having these drawbacks: After working for exactly five years, I decided to stop. Because I have a lot of experience repairing engines, I figured that we could just replace the bearings right now, and then the fan would start humming again. Plain bearings, not ball bearings, were inserted in it, despite the fact that the manufacturer had stated in the…

Below are some advantages: The standard of the work. The first fan of this kind produced by this business - I got it, but I can't recall exactly when; it was definitely more than eight years ago - it operates properly. Another disadvantage is that they are not present. Although the price may be steep, there is no denying the product's enduring quality.

Materials, plastic with marks on the material used, and conformity with the standards are all advantages that this product possesses. It can be seen that it drives the impeller, and there is vibration when the fan is turned on; however, thanks to the rubber mount of the rotor, this does not have a significant impact on the noise level or the beating of the fan itself. The fan is lovely, and it operates with very little noise. Despite the fact that one of the two that were purchased is not…

Some pros: Quiet operation Internal conduits for facilitating connecting of wires Simple and straightforward instructions minimal cost Cons: In my particular instance, the native channels for laying wires did not fit, and as a direct consequence, the front cover does not entirely close. This is not the most aesthetically pleasing appearance.

After a year and a half, the fan started to hum like a low-quality Chinese imitation, which encouraged me to take it out, clean it, and lubricate it. In spite of all the claims that it is difficult to disassemble, I can state without excessive modesty that if you have the right tools and the right people helping you, it is not difficult to disassemble at all. However, precision and attention must take precedence above everything else. I greased two bearings on the electric motor that I was…

Have put in more than ten years of work. I took it apart piece by piece, wiped it out with rubbing alcohol, oiled the moving parts with wd-40, and reassembled it. Allows for cleaning without having to be removed from the wall. If you pull the impeller toward you, it will come off the rod, and then you will have access to clean everything. The parsing to the rotor, which is mentioned farther down in the reviews, is not particularly challenging. There is a note about Italy printed on the motor. I

I purchased all three of these fans, and I hung one of them from the ceiling in the bathroom. During the procedure, it was discovered that the engine was not fixed in the housing in the typical manner. As a consequence, when the engine was turned on, the blades began to hit the walls of the housing, which caused the engine to turn off automatically. I don't know how long this method will hold up, but the ceilings managed to fix the motor in one of the fans with the assistance of glue. However,

Before I linked it to the almost 7-square-meter bath, it had previously been connected to the Fresh system, but I took it with me when I moved. He didn't start drawing good right away and put in a lot of practice. After I was certain that there was no more moisture in the restroom, I turned it off. As a consequence of this, I have two of these, one in an apartment and one in a house (in the guest bathroom), both of which are locations where the noise level is crucial in addition to the hood…

After making repairs, I installed such fans in my bathroom and toilet after completing the renovations. Due to the fact that we continually dry items in the bathroom and the fan does not switch off, he spent the better part of five years working there virtually nonstop. Extremely satisfied with the apparatus. Even though I have no prior expertise working with electricity, I was able to successfully remove the old fans and install the new ones in their place.

Its advantages include a reliable connection, high-quality material, and a relatively quiet operation. The cable outlet is only located in one of the four corners, which can be inconvenient in certain situations; in my case, I had to put it with the wrong side facing up.

To tell you the truth, after reading all of the laudatory evaluations and reviews, I did not expect this, but the vents 100 ma, which costs half the price, is superior in virtually every way. The only difference is that the noise level it produces is 36 dB, rather than 34 dB like this one. The setting of Silent is acceptable for the time being; but, if during the summer there is a backflow of air through the ventilation shaft, you will need to adjust it once again because there is not a typical