🔥 Wathai Blue Thermal Conductive Silicone Pad - 100x100mm, 1.5mm Thickness - for CPU GPU IC PS3 PS2 Xbox Heatsink Cooling Review

Works as advertised and is the correct thickness. I used this to route between my ASUS Strix backplate and the board to aid in heat transfer on the back of the chip. Without direct contact, it's just a cosmetic sheet, but now it really warms and helps transport heat. I used this in combination with a backplate compatible water block.

This isn't my best review, I've used it in a fairly custom repair and I really have no way of knowing if it's working properly. Used on a dishwasher with an overheated relay and the only way to see or verify the repair is to take the dishwasher apart. What if it doesn't fail, I won't do it. But since it was easy to use and the dishwasher works perfectly. I will give him 5 stars.

I used it on a Dell workstation with a new processor, I also used thermal paste and believe me it's been running for 26 hours. The processor is running at around 83% and keeping the heat around 2.5 degrees below what should be an application running fairly hard. I think I'll use this approach from now on, plus it's pretty cheap. Thanks Revane, if it wasn't for you suggest trying both anyway I'm satisfied.

I bought a used GTX 1080 that was advertised on ebay and it would have knocked me out at 83 degrees. I investigated the issue and found that a thermal pad is needed and evga is no longer giving them out. So I bought this element and installed it in the recesses of the radiator. And luckily for me it now reaches 94 degrees without jerks. Dude my card works so I bought another one for the sli setup. I also updated the dual bios from the nvidia website before installing the thermal pad.

I first tried installing a heatsink on my new 1TB NVMe drive and the stress test results weren't very good. Then check the Dell service manual that says it and they recommend a thermal pad between the drive and the motherboard. The problem is they don't tell you how thick it should be. Used the end of a pair of calipers to take some measurements and concluded it should be either 4mm or 5mm. Tried 5mm first, bingo! The drive stays 15°C cooler than with a heatsink on top. A 100x100 pack will hold

I bought these to replace 18 year old thermal pads on my GPU and Gamecube CPU. In truth, the stock pads were still in good shape, but I cleaned the inside of the console anyway, so I figured changing the pads wouldn't hurt. I chose pads with a thickness of 2 mm. The bearing pads were about 1.5 mm. But to be on the safe side, I chose 2mm. They worked great. The pads are easy to cut, sticky enough to stay in place but can be adjusted if needed. These are not self-adhesive pads, but they do have a