🎮 Enhance Gaming Experience with the 7 Watts Rapid Fire Mod Kit – Xbox One Controller 2 Pack Review

Quite a hassle to install. If you don't feel like high quality soldering I would do it for you. Or buy a ready-made controller.

Item received. The chip was not soldered together as described, you are buying two boards. The instructions are seriously the worst. IF you have never soldered like 1 hair tighten the head wiring. You will find it very difficult to understand. It took me 15 minutes. I wasn't impressed at all with setting up and exiting the rapid fire modes. There are no speed options at all. $40 IS NOT WORTH THIS MOD

These chips can ruin your controller I had three of these chips in my order and only one worked, the other two ruined two of my controllers. Yes 100% I installed correctly as shown in the instructions as said one worked so the buyer of the controller says there is no problem. but if you could potentially mess up your controller, I strongly don't recommend it. Zero troubleshooting support didn't get any response from them either.

First RTFM from website (don't bother with youtube videos). It will show you the points you need to solder. Second, the trigger points and pins on the power/sync points are very close to the other pins, if you are new to soldering be aware that this is not like replacing a potentiometer module. Everything is explained on the page in the instructions. I can't say MANUAL enough, you should read it. No issues with my controller, it works as intended and the mod options work as well. Total…

This product works as described BUT. This only works on single action pistols. For example Fortnite Beretta 9mm. only fires as fast as you can pull the trigger. In this mod you can hold down the trigger and the Beretta will fire in rapid mode. If you have a Scar weapon, it doesn't fire quickly; only as fast as Scar fires normally or with an automatic weapon. I've only tried this with Fortnite. The mod is easy if you are familiar with electronics and soldering; techie! If not, it will be…

Installed and works great! Please note this took me 2 1/2 hours and I have experience installing ICs in 360 controllers as well as replacing controller LEDs. Whoever makes the installation video is a soldering wizard, they pretended it was a 30 minute task. I ended up following the paper instructions because I was installing them on the original Xbox 1 controller, but they were more than detailed enough to help me. The most difficult contact points: the power and sync buttons. I'm not sure if…

I'm updating my review below: The mod chip seems to work with an XBox Series X when installed in an XBox One S controller and I'm now glad it works the way it does should. However, I'm sticking to what I wrote about their instructions. they are terrible! If I suspected that there would be very little instruction on how to install this mod chip, I certainly wouldn't spend money to buy it. I couldn't find any written instructions and only a YouTube video that doesn't help installing the mod chip…