🔧 8 Pack Dishwasher Dishrack Rollers and Studs - Lower Rack Wheel Kit for GE, Kenmore, Hotpoint Dishwashers Part WD35X21038 Review

These reels deserve 5 stars except for one major issue. Spindles can break when trying to insert them into the wheels. We broke 3 spindles because of a wheel with a small hole. We installed wheelsets. They work fine. However, I can't find any way to get replacements for defective spindles. There must be a way! Those who could install keep the wheels on the rack.

My old GE dishwasher was losing wheels and starting to lose its washing power. These wheels worked great and gave new life to the old car. Depending on the model, you can have additional wheels. keep her! It's always good to have backups. However, I don't think I'll be needing extra wheels any time soon. These bikes are strong and well constructed.

Just a warning. When you first look and see them you might think they don't work as part of the axle shaft is attached to the rail differently (actually better). But the new and improved way of putting the bar on the wire eliminates the tendency for the axle to slip off the bar wire. Just make sure you slip the wheel onto the included axle shaft before mounting the axle shaft to the wire stand. Perfect fit, great price.

Easy to install with improved connection system so hopefully they will last a lot longer than the originals. I'm so glad I finally decided to look them up at Revain - I've worn one or more of the old ones over and over since they've been coming off the shelf for a very, very, very long time! The insanity clause here applies to doing it as long as I've been doing it. Finally. enough! I observe. I bought. I made the changes and now I can see the results and the results are very good! :-) Life…

This was a great, inexpensive solution for our dishwasher that didn't have wheels. But the most important thing to know before you start is that you need to soak the parts in hot water to make the plastic more flexible. We broke a few because plastic gets hard in the cold. After doing some research, I read another review that suggested soaking parts in hot water before assembling. I am happy with this product, just wish there were instructions for soaking in hot water in the product description

My simple GE Profile Floor support assembly Wheels: Complete wheels: 1. Open the packaging and separate the wheels and axles2. Place the wheels back side up on a flat table surface3. Place the round part of the axle over the hole in the wheel and place your thumb on the flat part of the axle 4. In fact, increasing downward pressure was applied until the axle snapped into the wheel5. Repeat steps 3 and 4 as needed. To install the bottom caster: 1. Remove the empty bottom stand, turn the stand…

I bought this set of wheels and they worked GREAT! My Viking dishwasher is 9 years old and all of the bottom basket wheels have failed. I found a direct replacement for Revain. They were expensive but identical. I bought 2. And they were identical, including the same original design flaw. The hub that rides on the shaft is attached to the outer wheel (welded, glued? I can't tell). Creating a vulnerability. Everyone's failure mode was when the hub eventually pulled out of the wheel. When I…