White Erase Prize Midway Monsters Review

Bad design. Screw threads are stripped. It's not strong and you can't tighten it. he swings You will also need to put super glue on the arrow. Plan a visit to the hardware store.

Well I just got my steering wheel it was pretty easy to set up and it did the job well only had one small issue with it , the wheel kept hitting the rear brace while I was holding it, but I quickly tightened the rear nut and it started working like a dream

Very poor quality item. Every time someone spins the wheel, it wobbles and hits the back brace. I would NOT recommend this item. Honestly invest in a better quality wheel. Also, the arrow had a broken piece, but that could have happened during shipping. In any case. Here's what I think of this bike.

When I received the wheel it was damaged due to improper packaging. The orange-red clicker was broken and the screws and metal were rusty, as if it had been used before or had been sitting there for a while. The bike looked nice and was definitely big, but overall it didn't impress so we returned it and got a loan quickly.

Overall poor quality product and design. When you turn the wheel the whole thing wobbles unsteadily and it definitely feels weighted on one side. Also, the board was scratched when it arrived and the metal parts were rusty. We could handle it, but what really annoyed us was the shipping. The product came to us in a box wrapped in a single layer of tiny bubble wrap with a very thin piece of styrofoam on top. Mind you, the foam was about 6" x 3" and maybe half an inch thick, so it didn't protect…

Although some reviews noted poor packaging and sometimes damage upon receipt, I haven't had any such issues. My complaint would be that it is poorly built and requires a trip to the hardware store to properly align the base as well as properly balance and place the spinning wheel. The spinning wheel has a washer/nuts on the back of each pin that are too big in height/thickness and end up banging against the post which basically doesn't make the wheel move very well. The threaded rod that…

The bike was delivered today. The box looked like it had been run over 10 times. We didn't think of this product! The bottom screw has been removed. So don't install it on the base! The screw that goes through the center of the wheel is not long enough! When you spin the wheel, it vibrates because the screws on the back of the wheel hit the base. No matter how hard you tighten the middle screw, it still does. I had to add 7 washers to keep the wheel from dangling. dry erase section. The wheel…