🚗 Enhance Vehicle Safety with WINOMO 2pcs Flash Strobe Controller for Brake & Tail Lights Review

Very easy to install and works great with high mounted LED brake lights. I can't prove they prevented rear-end collisions, but I can tell you that after four months of two cars being wrecked by distracted drivers that crashed behind me, they've been added to every one of my cars I think i It's cheap insurance that adds an extra layer of protection and draws the attention of drivers behind you.

As it is advertised as a brake light control it only offers a flashing pattern to get the attention of drivers behind us. In order not to interfere with the expected brake lights, I've used this on my third (middle) brake light and it's working well so far. When activated, it flashes 3 times very quickly, then 3 times a little slower, and then it's on steadily. However, please note that this is only recommended for LED bulbs.

Once I found the brake light wire on my motorcycle, the installation was easy. Testing found it to work as expected before strapping the bike back on. After everything was in place, even before road testing, the strobe function failed. Now I only have through current from the device which makes the brake light work as if the strobe was not connected. To put it mildly, disappointed. I will update this review after installing the second device and hopefully using it on the road. crossed fingers

Good high center stop light. I have one installed on my Avalon and the other on my MR2 Spyder. Works well on both cars. I had the original tungsten bulb on Avalon, the reason for this is 4 and not 5 stars because with the initial tungsten bulb the first 3 flashes are so fast that the bulb doesn't respond fast enough, the second 3 flashes are much slower and worked well. I switched it to LED and it works much better with the first very fast flashes. It's too early to talk about durability.

Comes with two modules. Not sure why but good deal. Installed on a 2017 Ford CMax 5 bulb high mount stop light. After installation, only one of the 5 5W5 bulbs could work. This is normal if you have a motorcycle with a bulb. I needed all 5 for work. Easy to fix. I bought an ATO 194 with six 3030 chipset 2SMD T10 LED bulbs for $9 with a Revain discount. I made sure the bulbs were installed correctly and as per the instructions for using the LED bulbs, some of the LEDs did not work. Then you need

2 pieces for 10 dollars! Easy to install (once you know which wire to cut, check the service manual!). I bought these devices for two of my motorcycles. I had one before from a friend who gave me one of his. It was very easy to install and does what it promises. So I bought 2 packs as I have another bike and decided to keep the extra one as a backup. The scheme is as follows: when the brake is applied, it flashes with a flash, then flashes more slowly, then the brake light is on. I have always…