Wolfcraft 4640000 Dowel Master Pins Review

My first tool/dowel work. Dowelmaster works great, just read the instructions and take your time. BTY 8mm is exactly the same as 5/16 SAE. The videos on You Tube are helpful and the narrator is great!

I ordered this because I read reviews that they would work well with SAE bits but are 6mm too small to fit a 1/ A bit 4" and a 1/4" dowel (no pin) will not fit in a 6mm hole. 8/10mm can be used with its relative SAE equivalent but if you want to make 1/4 dowels for 1/2 or 3/8 inch plywood this product will not work.

I did not receive my order for 16 days after being notified of shipment. I immediately got to work because I was waiting for this dowel master with my project. Very good if you use it in your branch office or somewhere else where you have easy access, but this wasn't the case for my project. I'm trying to use this in a tight 7 inch space. What was difficult about working with it when you have almost no space for a cordless drill. So it's fine, but it all depends on how much space you have to…

Not bad for T-joints but when converting from 10mm metric dowels to standard dowels on board ends holes are drilled at an angle I bought a dowel for driving dowel holes in the Final fiber purchased It also takes a little time to set the depth to the 'right' depth for flush mounting on L-shaped joints (e.g., slide box, box). However, you can craft an attachment for quicker adjustment. I would definitely buy it again because I like how well it makes T-joints, but I recommend a different jig for…