🏕️ Enhance Ventilation: X-Haibei RV Roof Vent Lid Cover Replacement for Camper Trailer - White, 13x13x2 inches Review

Appears to be good quality but be careful when installing. It seemed a bit fragile when you tried to push it in. Take your time and be patient. I must add that the original cover seemed to be getting better and better, but it fell apart and had to be replaced.

I have an old pull out fan with a 12.5 inch fan. I couldn't find the original cover and when I looked for it most people said I had to cut a new hole. However, this cover was perfect for my old pop-up. You don't need to embed a whole new build

Fits perfectly in my Winnebago View bathroom vent but how difficult would it be to add instructions to make installation easier? The metal crossbar is riveted on one side and left loose on the other. It had to be inserted into the slot behind the loop. Failure to do this will result in another broken cap.

These van roof vent covers fit very well and replace the original covers. They arrived safe and sound exactly on the day they requested. The only thing I can advise the manufacturer is to screw the metal rod to the plastic cover with screws, just like the original covers. Using rivets allows the company to save pennies, but forces the installer to remove the screen and crank from inside the RV to install a new lift rod on the crank mechanism. This unnecessarily complicates the exchange and more

No instructions included. It appears to be thinner plastic than the previous cover. After watching a lot of YouTube videos I realized that my setup needs to be different. When my son installed the entire skylight, he didn't use the inside. Instead he did some fancy woodwork. So I couldn't take the screen off. Rivets drilled out of the new one. I removed the screws and a piece of metal from the old one. After I put the new cover on the skylight hinge, I put it on the new one and voila! Did. I…