Header banner
Revain logoHome Page
πŸ”§ yakamoz 1 15mm stainless welding metric kit logo

πŸ”§ Yakamoz 1 15mm Stainless Welding Metric Kit Review

3

Β·

Average

Revainrating 3.5 out of 5Β Β 
RatingΒ 
3.7
πŸ“ Dimensional Measurement, πŸ” Test, Measure & Inspect

View on AmazonView on Π―M

Media

(4)
img 1 attached to πŸ”§ Yakamoz 1 15mm Stainless Welding Metric Kit
img 2 attached to πŸ”§ Yakamoz 1 15mm Stainless Welding Metric Kit
img 3 attached to πŸ”§ Yakamoz 1 15mm Stainless Welding Metric Kit
img 4 attached to πŸ”§ Yakamoz 1 15mm Stainless Welding Metric Kit

Description of πŸ”§ Yakamoz 1 15mm Stainless Welding Metric Kit

Both Metric and Stadard reading | Welding taper gauge: 1-15mm (1/64-5/8 inch). Accurate figures and increments are etched into surface, easy to read. Polished, bright and clean without burr, rust laser engraved line and will not rub off. For measuring of cylindrical bores, hole, gap size, welding gap measure. Made of stainless steel, miniature and light weight, pocket size.

Reviews

Global ratings 3
  • 5
    1
  • 4
    0
  • 3
    2
  • 2
    0
  • 1
    0

Type of review

Revainrating 5 out of 5

It works, it's accurate and well made.

I bought this from CWI to check root gaps. It's accurate and well built. I would definitely buy this again if I lost mine, which I probably will. It would be nice if it came with a case, but that's not a deal breaker.

Pros
  • Test, measure and inspect
Cons
  • Not sure

Revainrating 3 out of 5

The instructions are wrong, the diameter of the hole cannot be measured

The instructions say it's good to check the wrong hole. If you don't sharpen the edges it will work for the hole as the integer is the radius and the edge of that rectangle won't match. I am a machinist with 30 years of experience. This is easily remedied by sharpening the edges to a point. If you want to use it to measure the distance between two flat planes then it's great. If you know these details, it's worth the money.

Pros
  • Industrial & Scientific
Cons
  • Available in white only

Revainrating 3 out of 5

Measuring the taper of holes can be very inaccurate. Correction table required

Taper gauges are inherently inaccurate due to their thickness when measuring a hole rather than a parallel slot. Holes on this thicker gauge. The actual opening of 4.82mm is measured on this gauge as 4.4mm on its scale due to the thickness of the cone reducing the measured diameter. Most reputable companies will provide you with a correction scale so you can roughly adjust the reading for a more accurate estimate of hole size. I like the dual scale on one gauge, both scales are fairly accurate…

Pros
  • Dimensional measurement
Cons
  • Expensive