🛠️ Imperial Yakamoz Combination Deburr Countersink Tool Review

Garbage, clean garbage and a waste of time and money.1. Cheap metal could not be broken through (pictured). I had to switch to a real drill to do this.2. The hole could not be sealed. I had to cut the hole manually.3. The canals are thin and prone to rupture (pictured). Too bad, because it really promised to be a time-saving tool.

I cut 12 holes with a 3/8-16 combi tap in a 1/4" steel angle in less than 20 minutes! The holes were already drilled but using the threading tool was very easy I wasn't sure what to expect when I ordered the set but the price was good so I took a chance I didn't have to worry the tool cuts nice sharp threads and makes it easy to thread even 1/4" thick steel. Buy with confidence.

Be careful not to use too much force when drilling. If you press hard, the tap will catch the bit and click. Work slow and light and use cutting oil if you have it. You don't fly to the moon, you just drill a hole and thread a thread into your metal. Protect your teeth slowly. Be wise, order two sets. It really saves time. The company stands behind its products. I will buy it again when I need to drill and seal tape in one operation.