🔨 Yonico 16147 Molding Router 2 Inch: Enhance Your Woodworking Projects with Precision Review

Put this item on my router table. At first it vibrated like you wouldn't believe it so I made my cut in about 5 cuts because I thought my router was running too fast (because I can't control the speed) porter cable 690, it didn't help at all. I had vibration marks, you won't believe it would take a lot of grinding to use this bit. From that point on, Freida's Will was always a bit boring when it was first unpacked. The seller was great even though I received the product within a few days of…

These are very large bits that require low speed processing. I dialed the speed on my router and the table started vibrating in a way I had never seen before. I revved it down to around 14,000 rpm and it settled down considerably. But the racquet itself wobbles a lot when you use it. I do 4-5 passes with it and it still leaves ripples and ripples on the finished product. It takes a lot of sanding to get a nice clean surface. I have a lot of Yonico Bits and they work well. But this one is an…

Attention buyers. I bought this piece to sculpt new kitchen cabinets. Used in a Bosch 1718 router installed on a Rockler router table. Set up a router table with a feather board to stabilize the soft maple lining. After installing the bit, I turned on the router and the table started vibrating. I adjusted the speed on the router to reduce vibration and started running the maple example. Knowing the size of the drill, I tried to take a VERY small piece of material, maybe 1/32 - 1/64 inch. The…