🐌 Hyundai Compatible Waterproof Snail Horn: 12V, 110-125db High/Low Tune - With Two Pairs of Horn Plugs Review

This horn comes with an adapter to easily plug into an existing power outlet. I have a 2018 Prius Prime Advance and it took me 10 minutes to remove and install this horn. I recommend this horn to other horns that need retuning to work. Piece of cake. slightly peezy, lemony squezy.

My daughter's 2013 Ford Focus lost its horn. After checking the fuse and relay, only the horn itself remained. This kit includes both horns (high and low) and various cable options. Replacing both horns and hooking them up took literally 10 minutes. The right cable with OEM connectors made the electrical part as easy as a couple of connectors. I can only recommend this horn set!

For anyone wondering: Fits 2022 HR-V Sport. You must use a plug that has a ground wire hanging from it. You can get the job done by removing the fender in front of the front wheels (there should be 4 clips that you need to remove). Near the top horn (closest to the battery) is a ground screw that you can use for the ground wire. The lower horn must be tilted to allow the ground wire to reach the nearest ground screw. Not that bad. They sound better than the factories.

However I didn't have a nose from my Honda HRV so they were easy to install. They fit as OEM gear, but I had to turn the mounting lever on the passenger side horn. Plug adapters fit perfectly. I sometimes honk my horn when there is little traffic because it sounds so nice. No more beep beep. Replacing the horns on the underside is something I would only do if I had done it sooner. Visibility is poor and it's quite difficult to remove and reattach these locking connectors even if you can see…

The Ford Edge 2020 comes with only 1 horn and its low frequency. It has a mount for 2 horns but they only attached 1. Sounds terrible and not very loud, I don't think it's safe. Ford is really cheap, maybe they saved $5? Shameful. Installation is pretty easy if you're a good wrench. You will need to remove the left headlight assembly to access the horn underneath. It's just a few screws and there are detailed videos on Youtube. It took about 20 minutes. These are much better horns, with a high…

I have a 2019 Toyota Rav4 Hybrid. Installation on rav 4 was very easy - find video on youtube. You will need 10 and 12mm wrenches and a screwdriver for installation. Remove the hood latch - just 3 screws (10mm)... Remove 6 plastic latches and two screws (10mm) from the front plastic panel. Pull the easy-to-bend plastic cover and you now have access to two horns secured with just one 12mm screw. Easy access to get your hand. I had ratchet wrenches from Port Freight which greatly expedited the…