Review on ITODOS Truck Tablet Mount All by James Prizgint

In your typical, everyday, "normal" setup, I would rate this as "good" or "fair". I installed it on a scooter yes i see there is more shock more vibration etc etc none of these things would be a problem if the mount could hold the object tighter it could probably be pulled a little tighter but if your device rotated to landscape mode, the clamps will crush your buttons. This button layout is very common on almost every Android device. You are forced to mount everything, but not centered. As it should be. Even with a normal installation in a car I see I got this thing that allows the tablet to slide right onto the bottom panel. Unfortunately, when you install it on a scooter or motorcycle, it "pulls out". " means your tablet ( in the BEST scenario) hanging from a g/sync charging cable and bouncing, sliding, sliding right next to you. On a two-wheeler, you can't always just reach out and grab it. (Remember, you're making 45, your $100 tablet is about to die and you're desperately trying to find a safe place to stop so you can pick up what's left of your tablet/phone/gps. .Incredible that it just hangs from the charging cable and bounces across the street. I also couldn't believe it didn't smash into pieces. The only thing that has happened to it, apart from a few minor abrasions on the corners, there is one small scratch on the camera lens. Well, could be worse. Lenovo? Great job on a quality product built like a tank! iTODOS? Same goes for your product. I see. It was good value. How much would it cost, put it like that to make it tighten right? He had 1 job.