Review on Enhanced Rugged Ridge 11231.02 Euro Guard Kit for 07-18 Jeep Wrangler JK, Including Turn Signal and Side Marker Protection by Kyle Awasthi

Everything about the design is positive. The metal is well finished, the painting is good. The attached instructions contain not only pictures but also text. To clarify the accompanying instructions, I've included comments below: The large guards (for the turn signal) have three tabs that align with the light holder. They were too narrow to fit over the appropriate area of the Light Node. By bending it slightly, you can easily attach the protection. You'll need to attach the longest tab first, and then the rest. If you flipped the tabs back, slide some of them back in after you've attached the protective cover. For the smaller guard (side lights), the instructions say you remove the assembly entirely. I found it difficult to depress the tab holding the lens to the wing assembly to perform this action. However, I found this removal unnecessary and was able to separate the two assemblies (wing flare and fender) far enough to reattach the guard. The total installation time was less than 20 minutes.