Review on 📱 ST25R3911B NFC Development Kit - NFC Reader with Onboard STM32F103 Controller, 1.3" OLED Display, SRAM, Micro SD Slot, Programming UART Debugging Interface, Multi-Protocol Support, Up to 1.4W Output Power by Daniel Robinson

Name: 📱 ST25R3911B NFC Development Kit - NFC Reader with Onboard STM32F103 Controller, 1.3" OLED Display, SRAM, Micro SD Slot, Programming UART Debugging Interface, Multi-Protocol Support, Up to 1.4W Output Power
Item: 📱 ST25R3911B NFC Development Kit - NFC Reader with Onboard STM32F103 Controller, 1.3" OLED Display, SRAM, Micro SD Slot, Programming UART Debugging Interface, Multi-Protocol Support, Up to 1.4W Output Power
Rating: 1

October 27, 2022

Not Work - Computer and Accessories

No operating instructions are included with the device. The controls were pretty easy to understand. After some trial and error I found that it only accepts .bmp image files. The device was turned on but could not send an image via NFC. The display indicated it was transmitting, but the NFC display received no power or image. Disappointed with this device I sent it back and again used my iPhone to send pictures to the NFC display.

Pros

Electronics

Cons

Quality

New products

Comments (0)

Please, sign in to write a comment

Top products in 🖥️ Desktop Barebones

Neural Compute Stick 2 by Intel

2.84

12 Review

DSD TECH 2 PCS IIC OLED Display 0.91 Inch: Perfect Arduino ARM Accessory

4.79

9 Review

Complete Kuman Raspberry Pi 4B 3B+ Kit: Breadboard, Expansion Board, Jumper Cables, Ribbon Cable, Resistance Pack

4.45

9 Review

🔌 UCTRONICS GPIO Breakout Kit for Raspberry Pi Pico - Assembled Pi T-Type Breakout + 830 Tie Points Solderless Breadboard + 40 Pin Male-Female-Male Rainbow Ribbon Cable + 65pcs Premium Jump Wires