Review on 🖨️ Enhanced ESUN Printer Filament Diameter Pantone Additive Manufacturing Products: Unleashing Unmatched Precision and Quality by Isaac Simpson

I was attracted to this filament because of the color choice, but after printing 4 rolls I refuse, this filament is rubbish. You need to print at higher PLA temperatures, the note on the box says 210-215, but this causes a lot of stress and bubbles (even at very high retract settings). If you lower the temperature to solve thread problems, you will end up with jam. My large prints had many problems with under-extrusion where parts of the layers were missing completely. To fix this I had to increase the temperature and flow rate, but I couldn't get a very smooth print, there was always evidence of under-extrusion. much luck.