Review on Toyland Buggy Buggy XMX 603 4x4, white by Wiktor Gajewski ᠌

I listed all the shortcomings in order for the buyer to be ready for what will have to be finalized, despite this, I highly recommend this car for purchase, if you understand electrics and your hands grow from the right place, a great designer for dad ! Improvements that I made - Replaced all 4 engines with RS 550 RPM 18,000. Replaced all power wires, including those that are soldered into the control unit. I took the power field-effect transistor from the control unit to a large radiator, replaced the transistor itself with a 200 ampere irl 3713, installed the radiator above the block, left the small radiator in the block itself on which the Schottky diode stands, fixed it, replaced all the connectors with expensive 20 ampere ones and 40 amp. accordingly, respectively, I threw out the 4wd switch, leaving it in the all-wheel drive mode, disassembled the ignition switch, bent all the contacts and soldered the outputs of the wires from it normally, reinforced the steering rack from below, lane. I attached the shock absorbers from above with plates (in the engine compartment too) . replaced the battery with a 2x7 amp manufacturer-DELTA. The result - the speed of 20 km / h does not heat up, the car goes to almost any "reasonable" hill, the power reserve is 40 minutes without a noticeable loss of power. and 20 minutes drive home. P/S Child 3.5 years old weight 15kg