Review on 🔥 CDI Electronics 182-4475R Ignition Coil - Chrysler/Force/Sears/Gamefinder (1981-1992) - 2/3/4/5 Cyl - High Performance by Matthew Fleming

parts arrived on time with all the parts needed. The original coil wires barely reach these terminals, so cut the white wire as close to the old coil as possible. I had to re-route the bottom wire of the coil to make it fit. Another problem is that the spark plug boots that connect to the coil are too long and will slip off immediately even when snapped onto the stud. I had to cut off the end of the boot to make it fit. IMHO this is a serious design flaw. There was enough room in the factory rolls for a standard length boot. It can also be screwed into old mounting holes with little effort. Doesn't quite fit perfectly. These coils sit a little crooked on the mount, but that's okay as they don't get in the way. Time will tell if they hold up.