Header banner
Revain logoHome Page
Park Seo Jun ᠌ photo
1 Level
103 Review
82 Karma

Review on Tenda Nova Mesh WiFi System (MW3) - Complete Whole Home Coverage, 1-Pack by Park Seo Jun ᠌

Revainrating 3 out of 5

I can't say that I was completely satisfied with the product.

There are really very few settings, it’s impossible to see the status of the port, it’s impossible to switch the second block to client mode, as it was written earlier, to see which block the device is connected to - you look like it’s connected to one, moved to another room where the second one is located - but in the application it’s still the same on the first block. Total: Plus only one price. I'll try to tinker, but it's possible that I'll give it up and switch to something more serious.

Pros
  • nice appearance low cost, there is a chance that it will work out of the box and is suitable for solving a simple task
Cons
  • The device is positioned as for people without IT knowledge - which is a plus, understandable disadvantages are few settings. But the information content of the application leaves much to be desired. And then everything is fun, use case: I put it first behind my router, everything started in bridge mode out of the box - a plus for that. After reading the manufacturer's recommendations, I decided to remove my router and use the device for its intended purpose, that is, it itself receives and distributes the Internet, then I had a sexual relationship with these miracle machines for about 2 hours in an attempt to work as expected (with my experience setting up a mesh on Mikrotik in 30 minutes ). The device, for unknown reasons, has addressing 19220228.5.1 out of the box (respectively, all devices that are static at home go to the forest) - when trying to change to its addressing, it first gave an error, after resetting all the boxes, it was possible to give its network, but a more wonderful DHCP event happened handed out addresses with Amazon different from his address - respectively, the devices did not see the Internet. When connecting the second unit via cable, the device is either available or not, periodically there is no connection to the unit, etc. The firmware is of course the latest. Blocks about 5 times completely reset and configured from scratch. I had to leave the second unit on a wireless connection, because it's just a pity to waste my time.