
all clip-on ferrites (with one exception) (have minimal technical details. At MINIMUM they should specify (1) maximum current to saturation (where EMI filtering disappears) and (2) either the effective frequency range or the material (from which you can look at the frequency range) Yes, they're cheap compared to other sources, but it's hell if they're going to do that some good by being conducted EMI to be filtered out. As you can imagine, for my application (filtering 180-200MHz in the cable that runs the cable from the solar panels to the inverter) they didn't make a socket S.

Radar detector Inspector Spirit
39 Review

StarTech.Com HDMI To VGA Cable – 6Ft 2M - 1080P – Active Conversion – HDMI To VGA Adapter Cable For Your VGA Monitor / Display (HD2VGAMM6)
38 Review

SilverStone F1 Monaco S radar detector
82 Review

Waterproof Hard Laptop Sleeve Case For MacBook Pro M1 14-Inch 2021, MacBook Air M2 13.3'' 2022-2018, MacBook Pro M2 13'' 2022-2016, Dell XPS 13, Surface, HP, Acer - Cloudy Marble Design By FINPAC
39 Review

✈️ Enhancing Aviation Safety: ASA-OVC View Limiting Device for Clearer Vision in Overcast Conditions
9 Review

🛩️ Stratux ADS-B Dual Band Receiver: Advanced Aviation Weather and Traffic System with WAAS GPS, AHRS, Battery Pack, Suction Mount, Antennas, SDR
9 Review

🔍 MANN-FILTER W 811/80: The Optimal Oil Filter for Enhanced Engine Performance
11 Review

🎧 FARO Aviation Headset Converter: Low to High Impedance Adapter for General Aviation (GA) and Military Headsets
9 Review