Inner hole needs to be machined to about 1/64 to avoid getting stuck on short stem Gasket is a pain because the tool got stuck on a short shaft and had to be knocked out. After partially removing the gasket, I had to sand down the inside until it was no longer sticky.
π§ Dorman 614-030 CV Joint Boot Tool for Easy Installation
9 Review
Enhance Your Truck's Power with OrionMotorTech Heavy Removal Adapters
8 Review
OEMTOOLS 24429 Ford 3-Valve Spring Compressor: Efficient Tool for Ford Valve Spring Compression
9 Review
π§ OEMTOOLS 27308 Ball Joint Separator: Adjustable from 1-1/8" to 2-1/8", Perfect for Common Ball Joint Sizes, Enhanced Steel Separator Mechanism with Black Oxide Pins
9 Review