Review on CERPRiSE Filament: Achieve No Tangling and High Dimensional Accuracy by Joseph Pudic

So I type quite a bit and I understand pretty well what good thread is. Most of my filament went into PSA's prints or something, so I'm constantly trying to replenish my supplies. Filament is one of those things, especially when it comes to PLA, it either works or it doesn't. It works well and has no printing problems at all. I will have to print more of these and more rolls overall, but first impressions are good. I printed at 205°C without a heatbed and all I used was a small glue stick. I would say that I have no problems lifting at all. This thread does not blow or burst and also has very good layer adhesion. I don't print particularly fast (50mm/s) so if your printer is better than the Xvico X1, Anet A2 or Anet A8 you shouldn't have any problems with this filament.