Review on 370PCS Keadic Female Thread Knurled Nut Brass Threaded Insert Embedment Nuts Assortment Kit, M2 M3 M4 M5 Sizes by Matthew Outlaw
Awesome inserts for 3D printing
Good inserts for 3D printed parts. I ran some tests and posted some photos of the results. I simply run a metric screw through the insert, heat it for a few seconds with a small butane torch, and then pop it in the print. The simulation chart shows what diameter I used to ensure each insert fits properly. I hope my experiment helps you get started using these wonderful products! All glory be to the Lord Jesus!
- Product material
- Socket required
New products
Comments (0)
Top products in 🔩 Nails, Screws & Fasteners
🔩 Eowpower 50 Pieces of 1/4"-20 x 7/16" Zinc Plated Tee T-Nuts with 4 Prongs
10 Review
Computer chair Bureaucrat KB-8 for executive, upholstery: textile, color: black
18 Review
Wall-ceiling lamp Estares Saturn 60W R-470-SHINY/WHITE-220-IP44, 60 W, 47 x 47 cm, armature color: white, shade color: white
13 Review
SOKOL computer table KST-14, corner: left, WxDxH: 140x123.5x182.8 cm, color: sonoma oak/white
50 Review
Another interesting products
Gorilla Waterproof Patch & Seal Liquid - Black 16Oz - Ultimate Solution For Quick Fixes (Pack Of 1)
39 Review
💪 Bondic UV Liquid Plastic Welder - Fast Cure, Strong Adhesive Repair Kit for Home, Garage, Outdoors, etc. - Complete Starter Set (LED Light & Liquid Cartridge in Compact Tin Case)
9 Review
Hemway Glitter Grout Tile Additive: Sand Gold Sparkle For Your Bathroom, Kitchen And Wet Room Tiles - Easy To Use And Temperature Resistant!
10 Review
🌳 Efficient Drip-less Wood Glue Dispenser, 16 Oz Bottle
8 Review