Review on 🔧 Spectre Performance 771 Low Profile Dual Plenum Kit 45°/90° Tube by Jim Velasco

If you're looking for a good looking, low profile plenum this is it. I only had a few inches to the carburetor and hood, and it was on point. I also had limited space to place the tubes on the sides and forward. I used a Specter 4213 stud kit, Specter 4208 air cleaner nut and Specter Performance 8161 black air cleaners. Cut the stud, remove the wing nut that comes with the 4208 kit to complete it and install then the filters. It looks very clean. Be sure to check the distance from the top of the carburetor to the bottom of the hood. Even subtract 1/8 to be on the safe side. Also remember to check the width you need, the down angle and the forward distance you have. You could find simple hoses, cables and mounts in ways you didn't suspect. Contact the seller with any questions, especially if you have a non-standard engine.