Header banner
Revain logoHome Page
Michael Hemmig photo
India, New Delhi
1 Level
741 Review
63 Karma

Review on Moog K500013 Ball Joint by Michael Hemmig

Revainrating 4 out of 5

Turns the mother.

Works well so far. My alignment issues have been resolved. I was frustrated with his setup. This ball joint is flat bottomed which means it cannot be held down when tightening. The nut rotates with the bolt. There is a hex hole on the top, you can put a hex head in it and lock it, but it will not stop the rotation. Not only could I not put the mother on, but I could not remove it either. I had to saw through the bottom and use a flathead screwdriver to hold it in place. Once in it works well but for the price the mechanism is disappointing. Maybe I got a defective one.

Pros
  • Setting range from minus 1 to 1 degree.
Cons
  • Some little things