Review on 🛹 2-Pack Meepo Electronic Skateboard Hub Motor PU Sleeves - Replacements/Spare Parts by Chris Cruz

This is a part direct from Meepo and fits my new Meepo V3. This is a mandatory replacement for 90mm bushings and wheels. I have ridden much better and smoother with these sleeves than the 90mm. To be honest, Meepo now has to deliver his boards with 100 mm simply because of the smoothness. A note on removing the hub: you will need to remove the hex head screws from the back of the wheels to pry the magnetic hub out of the rest. Engine. DO NOT USE THE HEX TOOL SUPPLIED WITH MEEPO. You will have a much better experience if you use a TEMPLE with a properly sized (1/8') hex head screw. I tried using a hex wrench from the Meepo set. The metal used in this tool was too soft for the two screws And I REMOVED THEM It was such an awful agony. I ended up using a Dremel tool to etch new notches in the stuck screws and used a tiny screwdriver the ratchet to slowly remove it. I would have avoided all this hassle if I had used a ratchet with the correct hex. So if you buy those 100mm wheels, USE A 1/8" HEX RATCHET to loosen the bolts on the bikes. They don't loosen any screws and get the job done quickly.