Review on Ecolink Intelligent Technology PIRZWAVE2-ECO-2 Z-Wave Easy Install Pet Immunity Motion Detector - White by Chad Sornsin

Excellent Motion Detector. Although this detector is not directly supported by Wink, it has been running successfully on the Wink platform with Wink Hub for about 4 months. The detector, when used with Wink, has a delay of more than 10 seconds between the time the signal is received and the time the light or other application function can be activated. It doesn't work with all app features; However, Wink Hub recognized it as a motion detector when properly connected. Wink hubs seem to interpret the signal normally; However, sometimes the detector sends a signal that Wink Hub doesn't understand, and this can result in the event not being triggered or an erroneous entry in the Wink application's activity log. In the application it can display the name of the sensor and "Motion detected started" or the name of the sensor and "Motion detected stopped" if programmed to show a stopped motion depending on how it has been programmed to respond motion detected. Usage/Installation Tips: - Check the position of the detector with the two small adhesive strips provided to ensure the sensor can accurately detect movement, and don't ignore them if it detects that the movement is below a certain value is a pet. - Two There are PET1 and PET2 modes that need to be set by physically opening the front cover of the sensor and moving the jumper to PET1 or PET2 according to the user manual (always follow the instructions and remove the battery before using move the jumper). These modes are different levels of sensitivity to the underside of the motion sensor to accommodate different pets that could potentially cause false alarms if accidentally detected - the red light will flash quickly when motion is detected, or flash at pre-programmed intervals to indicate , what mode there is a sensor (pairing, pairing, etc.) - the sensor takes at least 3 minutes to reset itself and indicate that the movement stopped or started again within a reasonable time. Overall I think this is a great simple motion detector that can do its job well when installed and used according to the sensor platform instructions and instructions. will be paired with Check with the platform/hub manufacturer first to see if the sensor might be compatible.