Media could not be loaded. I routed the water through the wall of the pond shown in the photo. The flanges on both sides are too small in diameter. When you tighten it you should almost destroy the seals to get enough compression to prevent leakage. If the flange diameter was about 50% larger, the gasket would not deform as much and would seal better. I cut a hole in the side of the pond close enough to the size of the fitting I needed to thread it through so I couldn't get much closer. I'm still getting a drop every few minutes, so that'll have to do. At the end of the season I'll have to see if I can make big pucks on both sides to ensure a better fit.
Upgrade Your Draft Beer Kegerator With The TerraBloom CO2 Keg Pressure Regulator - Dual Gauge Heavy Duty Unit With Safety Features
16 Review
Joywayus 5/8" ID Hose Barb Hex Union Brass Fitting Water/Fuel/Air With 10 Stainless Steel Clamps (Pack Of 5)
13 Review
12V Brass Solenoid Valve, 3/4" Electric Air Valve For Water, Air, Gas, Fuel And Oil - Normally Closed By Beduan
10 Review
1 Inch Beduan Brass Electric Solenoid Valve, 12V Normally Closed Air Valve For Water, Gas, Fuel, And Oil
10 Review