Header banner
Revain logoHome Page
Kevin Mariappan photo
1 Level
1310 Review
73 Karma

Review on CUBICON Printer Filament 1 75Mm Package Additive Manufacturing Products for 3D Printing Supplies by Kevin Mariappan

Revainrating 5 out of 5

Real high temperature ABS filament.

I tried several other press threads. Hatchbox and Domestic, and manufacturers continue to tinker with fillers and additives that are said to make the press easier to print, and as a result the press doesn't behave like a press. This thread prints like a press. Bed set to 110, hotend to 250 for 1st layer 245 after that. Fan low for overhangs and bridges and off for easier detail. There is no warping near the bed, bridges and overhangs are printed well and cleanly. The base case only has the sides and top open so obviously hot air is escaping, but other than that the envelope is around 45C. Fan tuning to find the right combination for clean runs and reduced kinking. Fewer fans, prevent large parts from deforming. Small details are no problem. My only complaint is that the red on the reel comes out very muted and not bright red. The rest of the print is very clean.

Pros
  • Industrial & Scientific
Cons
  • Some errors