Review on 🔧 Outwater Industries - 25ft White 3/4" Center Barb Tee Moulding T Molding Hobbyist Pack for Small Projects, Arcade Machines, and Tables by Chris Riley

I've used edge banding on many projects and it's good for edges that don't require too much maintenance. I used this product on a project where I knew the edge was going to bump a bit. I had to buy a new router to cut a notch in the notched T, but it only cost $20+. Once the router is set to cut the correct depth so the slot is EXACTLY in the center of the board, it works quickly. I used a 1/16 inch slot cut from 3/4 thick melamine. The fit was so tight I couldn't insert the barb by hand, but tapping with a plastic mallet worked really well. I was very happy with the finished product, it looks much better than the iron on the edge. However, it is MUCH more expensive compared to November 2020 prices for 3/4 inch 250ft iron reels with iron at about 0.12 per foot. Tee is .36 per foot