Review on 🖤 Black Nylon 3D Printer Filament by KODAK by Dawson Schmidt

I'm always looking for a good CHEAP filament. Recently played with nylon after a lifetime of ABS printing. Let me start by saying this nylon looks TERRIBLE straight out of the bag. Look at the photos. The thread has many bends and AIR BUBBLES. I mean there are a lot of defects in the filament itself. It's not what I expect from a big company like Kodak, but it is. After drying for a few days in my heated and closed 3D printer (70-80°C), I tried it out. I printed this hot at around 270-290C and a layer temp of 90. The layer is a GAROLITE film which is perfect for nylon adhesion (actually almost too much). The printing speed is about 40-50. All in all, the print quality with the 0.6 mm nozzle was damn good. Photos are attached. Overall, this is a decent and CHEAP nylon thread. I will buy again.