Review on π© Stainless Compression Fitting Coupler by HorizNext by Justin Albright
High quality connector but requires brass locking rings for proper sealing.
I purchased this stainless steel compression fitting to connect my 3/8 inch stainless steel rigid tubing to the An-6 flexible fuel supply hose. The supplied stainless steel compression rings for the sewer shut-off tube were not compressed enough to create a proper seal, resulting in a fuel leak. I had to use Swage-Lok brass compression rings. They are properly sealed.
- Fittings
- I am writing back
New products
Comments (0)
Top products in π§ Fittings
Joywayus 5/8" ID Hose Barb Hex Union Brass Fitting Water/Fuel/Air With 10 Stainless Steel Clamps (Pack Of 5)
13 Review
1 Inch Beduan Brass Electric Solenoid Valve, 12V Normally Closed Air Valve For Water, Gas, Fuel, And Oil
10 Review
High-Quality QiiMii Stainless Steel Sanitary Clamp With Silicone Gasket - 2 Inch, Single Pin Tri Clover Design
16 Review
6 Pack Miahart Adjustable 304 Stainless Steel 4 Inch Hose Clamp Duct 91Mm-114Mm Worm Gear Pipe Clamp For Automotive, Mechanical Agriculture.
18 Review
