Review on π EDGE INDUSTRIAL Reusable Adapter Fitting by Dominic Mayo
Excellent repair best in fittings
Very good design and very good price. The hose must have a very clean cut to install the sleeve. I used Windex to lubricate and bolt on the fitting. After the fitting was installed, a light coat of grease was applied to the threaded insert and hose ID. Clamped in a vise, both fittings lightly mated.*Compare the price of this repair end versus the cheap snap on type and fuel line clamp, this is not a problem. Highly recommended.
- Stylish and modern design
- Slightly wrinkled
New products
Comments (0)
Top products in π§ Fittings
12V Brass Solenoid Valve, 3/4" Electric Air Valve For Water, Air, Gas, Fuel And Oil - Normally Closed By Beduan
10 Review
High-Quality QiiMii Stainless Steel Sanitary Clamp With Silicone Gasket - 2 Inch, Single Pin Tri Clover Design
16 Review
6 Pack Miahart Adjustable 304 Stainless Steel 4 Inch Hose Clamp Duct 91Mm-114Mm Worm Gear Pipe Clamp For Automotive, Mechanical Agriculture.
18 Review
Joywayus 5/8" ID Hose Barb Hex Union Brass Fitting Water/Fuel/Air With 10 Stainless Steel Clamps (Pack Of 5)
13 Review
